For more information, see the Firepower Management Center Configuration Guide for your version. If you reimage an FTD device managed with the Firepower Management Center, and the FMC and the device are running Version 6.3+, you can use the FMC web interface to back up the device configuration before you reimage, and restore the backup after you reimage.If you have no backup you must recreate the device configuration manually, including interfaces, routing policies, and DHCP and DDNS settings.For more information see the Cisco Firepower Threat Defense Configuration Guide for Firepower Device Manager for your version. If you have a recent, externally stored backup, you can restore the backed-up configurations after you reimage.If you reimage an FTD device managed with Firepower Device Manager:.For FTDvs using Firepower 7.0+ on AWS, a new deployment has no c onfiguration and there is no default password you supply an admin password at deployment time. With the exception of FTDvs using Firepower 7.0+ on Amazon Web Services (AWS), a new FTDv deployment has no configurations, and the admin password is Admin123. Reimaging a physical device erases its configuration and resets the admin password to Admin123. See the Cisco ASA and Firepower Threat Defense Device Reimage Guide for instructions.įor virtual FTD devices, you must replace the device with a new deployment. See the Cisco FXOS Troubleshooting Guide for the Firepower 1000/2100 Series Running Firepower Threat Defense for the Reimage Procedure on these platforms.įor FTD devices running on ASA 5500-X and ISA 3000 models, you must reimage the device. To rese t a lost admin password for a Firepower Threat Defense (FTD) logical device on Firepower 93 platforms, follow the instructions in the Change or Recover Password for FTD through FXOS Chassis Manager guide.įor FTD devices running on Firepower 1000/2100, you must reimage the device. Firepower Threat Defense: Reset the Admin Password The 70 Series devices are supported through Version 6.4. Note: References to the Firepower Management Center CLI apply only to Versions 6.3+. These instructions cite the Firepower Management Center the same instructions apply to the Defense Center. The admin account on managed devices is the same for CLI access, shell access, and web interface access (when available). The Defense Center and Firepower Management Center (FMC) provide different admin accounts (with separate passwords) for Command Line Interface (CLI)/shell access and web interface access (when available). This document provides instructions for resetting the password of the admin account on FireSIGHT, Firepower, and ASA FirePOWER Services appliances, including in situations where that password has been lost.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |